||Dyne level of the substrate : <60 dyn/sq.cm
||Add JAR-18 by 5% to improve adhesion. Mix well so that the additive does not remain on the container or mixing tool. Do not use the mixture just after the mixing as prints might be uneven. Let the mixture stand for 20 minutes before use. The mixture has pot life of 8-12 hours. Check the adhesion before print.
||Add REDUCER by up to 10% to lower the viscosity.
||Add EXTENDER by appropriate quantity to lower density.
||Add JAR-8 or JAR-15(accelerator) when the standard curing cannot be obtained due to degrading of the lamp or type of substrate.
||Standard curing conditions (These conditions change depending on the substrate.)
metal halide lamp 120W/cm,
Distance from focus : 10 cm
Conveyor speed : 15 m/min
Integral light : approx. 200 mJ/sq.cm
||Mesh : Polyester 300 meshes
||Thickness of sol : <= 10microns